TESONMAGIC

PACKAGING

TW-200 is an emulsion with nano-enhanced design to protect surfaces against moisture. This waterproofing system respects the environment since it is entirely formulated in a water base. It is free from any organic solvent and it does not contain ecotoxic surfactant. After it had dried on the surface, tesonmagic repels water and allow walls to breathe. Experience acquired shows that nano water repellents are a good answer to humidity problems in construction materials, particularly when for esthetical reasons the natural aspect of the material should be preserved. Tesonmagic has been awarded a test certificate by CSTC (Center Scientifigue et Technuque de la Construction-Belgium).

ADVANTAGES:

• High water penetration resistance by capillarity action
• Outstanding hydrophobia and beading effect.
• Versatility allowing its use on many porous mineral materials.
• Very good vapour permeability, breathable with very low surface tension.
• Very slight change in the material’s natural color and aspect.
• Improve pollution resistance and easy for cleaning.
• UV & chemical resistance, reduce efflorescence.
• Penetrate 2-5mm of porous substrate for long-term waterproofing.

APPLICATION:

• Concrete, Pre-cast concrete.
• Brick, Masonry.
• Stone, Sandy rock.
• Tile Joint.
• Mortar.

COVERAGE:

Optimal waterproofing performances of the treated materials will only be obtained if adequate quantity of Teson Magic is applied : A one liter solution of Teson Magic may be sufficient to treat a surface of 3 m2, but this quantity may vary since it essentially depends on the type of substrate and its absorption capability (from o 2 litres per m2, depending on the substrates).

• Mortar, Concrete : 0.3 to 0.5 l/m2.
• Sand stone : 0.4 to 0.6 l/m2.
• Lime stones : 0.4 to 2 l/m2.
• Mineral plaster : 0.6 to 0.8 l/m2.
• Brick : 0.6 to 1.2 l/m2